I have a 2014 Heartland Wilderness model 2775RBS.
Noticed that the outside skin panel was cut to short and is now coming out from under the corner molding where the side panel meets up to the front skin panel. Need to know now the trailer is made, is there a "L" shaped frame the two skins connect too? If so then I can install a fastener (sheet metal screw) through the outer skin into the "L" frame. This should help keep the outer skin panel from being ripped off by the wind while driving down the road. This should also stop any water from getting into the trailer.
Thanks,
Craig
e-mail: calldaddy1st@gmail.com
Noticed that the outside skin panel was cut to short and is now coming out from under the corner molding where the side panel meets up to the front skin panel. Need to know now the trailer is made, is there a "L" shaped frame the two skins connect too? If so then I can install a fastener (sheet metal screw) through the outer skin into the "L" frame. This should help keep the outer skin panel from being ripped off by the wind while driving down the road. This should also stop any water from getting into the trailer.
Thanks,
Craig
e-mail: calldaddy1st@gmail.com